Installing The Unit - Kenwood DMX5019DAB Instruction Manual

Monitor with receiver
Table of Contents

Advertisement

Installation and Connection
Installation and Connection
Parts list for installation
Note: This parts list does not include all the package
contents.
¥ Wiring harness (× 1)
ø Extension parking cable, 2 m (× 1)
π Trim plate (× 1)
[ Mounting sleeve (× 1)
" Extraction keys (× 2)
] Microphone, 3 m (× 1)
Installation procedure
1
Remove the key from the ignition and
disconnect the
battery.
·
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector A and B on the wiring
harness and connect it to the speaker
connector and external power connector
in your vehicle.
5
Connect the wiring harness to the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7
Reconnect the
battery.
·
8
Configure <Initial SET-UP>. (Page 4)

Installing the unit

Installing the unit using the mounting
sleeve
Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
Installing the trim plate
π
ENGLISH
43

Advertisement

Table of Contents
loading

Table of Contents