Ferris IS2000ZKAV3461SS Operator's Manual page 8

Zero-turn riding mower
Hide thumbs Also See for IS2000ZKAV3461SS:
Table of Contents

Advertisement

• Never allow children or others in or on towed equipment.
• On slopes, the weight of the towed equipment may cause
loss of traction and loss of control.
• Travel slowly and allow extra distance to stop.
• Do not shift to neutral and coast down hill.
Children
Tragic accidents can occur if the operator is not alert to the
presence of children. Children are often attracted to the unit and
the mowing activity. Never assume that children will remain where
you last saw them.
• Keep children out of the mowing area and under the watchful
care of another responsible adult.
• Be alert and turn unit off if children enter the area.
• Before and during reverse operation, look behind and down
for small children.
• Never carry children, even with the blade(s) off. They may
fall off and be seriously injured or interfere with safe unit
operation. Children who have been given rides in the past
may suddenly appear in the mowing area for another ride
and be run over or backed over by the machine.
• Never allow children to operate the unit.
• Use extra care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
Emissions
• Engine exhaust from this product contains chemicals known,
in certain quantities, to cause cancer, birth defects, or other
reproductive harm.
• Look for the relevant Emissions Durability Period and Air
Index information on the engine emissions label.
Ignition Systems (Gasoline Models)
• This spark ignition system complies with Canadian
ICES-002.
Service and Maintenance
To avoid personal injury or property damage, use extreme care
in handling gasoline. Gasoline is extremely flammable and the
vapors are explosive.
Safe Handling of Gasoline
• Extinguish all cigarettes, cigars, pipes, and other sources of
ignition.
• Use only approved gasoline containers.
• Never remove the gas cap or add fuel with the engine
running. Allow the engine to cool before refueling.
• Never fuel the machine indoors.
• Never store the machine or fuel container where there is an
open flame, spark, or pilot light such as near a water heater
or other appliance.
8
• Never fill containers inside a vehicle or on a truck bed with
a plastic bed liner. Always place containers on the ground
away from your vehicle before filling.
• Remove gas-powered equipment from the truck or trailer
and refuel it on the ground. If this is not possible, then refuel
such equipment on a trailer with a portable container, rather
than from a gasoline dispenser nozzle.
• Keep nozzle in contact with the rim of the fuel tank or
container opening at all times until fueling is complete. Do
not use a nozzle lock-open device.
• If fuel is spilled on clothing, change clothing immediately.
• Never over-fill the fuel tank. Replace gas cap and tighten
securely.
• Use extra care in handling gasoline and other fuels. They
are flammable and vapors are explosive.
• If fuel is spilled, do not attempt to start the engine but move
the machine away from the area of spillage and avoid
creating any source of ignition until fuel vapors have
dissipated.
• Replace all fuel tank caps and fuel container caps securely.
Maintenance and Storage
• Always observe safe refueling and fuel handling practices
when refueling the unit after transportation or storage.
• Always follow the engine manual instructions for storage
preparations before storing the unit for both short and long
term periods.
• Always follow the engine manual instructions for proper
start-up procedures when returning the unit to service.
• Never store the machine or fuel container inside where there
is an open flame, such as in a water heater. Allow unit to
cool before storing.
• Shut off fuel while storing or transporting. Do not store fuel
near flames or drain indoors.
• Keep all hardware, especially blade attachment bolts, tight
and keep all parts in good working condition. Replace all
worn or damaged decals.
• Never tamper with safety devices. Check their proper
operation regularly.
• Disengage drives, lower implement, set parking brake, stop
engine and remove key or disconnect spark plug wire. Wait
for all movement to stop before adjusting, cleaning or
repairing.
• Clean grass and debris from cutting units, drives, mufflers,
and engine to prevent fires. Clean up oil or fuel spillage.
• Let engine cool before storing and do not store near flame.
• Stop and inspect the equipment if you strike an object.
Repair, if necessary, before restarting.
• Park machine on level ground. Never allow untrained
personnel to service machine.
• Use jack stands to support components when required.
ferrisindustries.com

Advertisement

Table of Contents
loading

Table of Contents