Mira Zest 7.5 Installation, Operation And Maintenance Manual page 19

Mira Zest 7.5 and 8.5
Read the section 'Important Safety Information' first.
THE SPRAY PLATE HOLES MUST BE KEPT CLEAR. The spray plate should be
regularly removed and cleaned in descalent. Lack of regular spray plate cleaning will
lead to poor performance and cause early failure of the appliance.
1. Switch on pullcord or wall mounted switch.
2. Rotate the TOP control knob to position 'HIGH' (Full Power).
3. Wait 15-20 seconds for warm water to reach the handset.
4. If necessary turn the BOTTOM control knob slowly to adjust temperature. Allow
10-15 seconds for the adjusted temperature to reach the handset. The control
knob operates through approximately ¾ of a turn from cold to hot. Clockwise rotation
will give warmer water with less flow. Anticlockwise rotation will give cooler water
with more flow.
Note! Should the product alternate (Hot - Cold). Adjust the bottom control knob
anti clockwise to reduce the temperature. This is normal operation if too high a
water temperature is selected.
5. TO TURN OFF turn the TOP control knob anticlockwise to the 'STOP' position.
6. A small amount of water may be retained in the shower fitting after the shower
control has been turned off. This may drain over a few minutes.
(For summer economy showering use the 'MEDIUM' (Half Power) position on the
control. For a cold shower select 'LOW'.
Note! 'LOW' selection can be achieved without electrical power.
7. Switch off at the pull-cord or wall mounted switch.
19