Saturn 2009 VUE Green Line Hybrid Owner's Manual page 180

3-78 Instrument Panel
Using the Digit Dial Command
J 0
1. Press and hold /
two seconds. The system
responds with "Ready" followed
by a tone.
2. Say "Digit Dial". The system
responds with "Digit dial
using <phone name>, please say
the first digit to dial" followed
by a tone.
3. Say the digit to be dialed one at
a time. Following each digit, the
system will repeat back the
digit it heard followed by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say "Dial".
The system responds with "OK,
Dialing" and dials the number.
•
If an unwanted number
is recognized by the system,
say "Clear" at any time to
clear the last number.
•
To hear all of the numbers
recognized by the system, say
for
"Verify" at any time and the
system will repeat them.
Using the Call Command
1. Press and hold
two seconds. The system
responds with "Ready" followed
by a tone.
2. Say "Call". The system responds
with "Call using <phone name>.
Please say the name tag"
followed by a tone.
3. Say the name tag of the person
to call.
•
If the system clearly
recognizes the name tag it
responds with "OK, calling,
<name tag>" and dials
the number.
J
0
/ for
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and hold
2. After the tone, say "Re-dial". The
•
If the system is unsure it
recognizes the right name tag,
it confirms the name tag
followed by a tone. If
the name tag is correct, say
"Yes". The system responds
with "OK, calling, <name
tag>" and dials the number. If
the name tag is not correct,
say "No". The system will ask
for the name tag to be
re-entered.
J 0
/ for
two seconds. The system
responds with "Ready" followed
by a tone.
system responds with "Re-dial
using <phone name>" and dials
the last number called from the
connected Bluetooth phone.