Switches; Connection Ports - SATO M5900RVe Operator's Manual

Unit 1: Introduction
CONTROL FEATURES

SWITCHES

Power Switch
Line Key
Feed Key
DSW2 & DSW3
DSW1

CONNECTION PORTS

AC Power Input
Interface Port
Ext. Interface Port
Memory Card Slot
LCD DISPLAY
LINE KEY
LINE
PRINT OFFSET
DSW2
PANEL COVER
SATO M5900RVe Operator Manual
Two position on/off switch that controls power flow to the system.
Toggles between on-line and off-line modes. When on-line, the
printer is ready to receive data from the host. Acts as a pause during
print by taking the printer off-line. Also used as a scroll-and-enter
interface for printer setup.
Feeds one blank label through the printer when off-line. When the
printer is on-line, another copy of the last label will be printed. Also
used as a scroll-and-enter interface for printer setup.
Sets operational parameters of printer.
To configure optional RS232 communication card. Located on card.
Connector permits 115V, 50/60 Hz supply via supplied cord.
Connector for interface harness. Must be connected for the printer to
be operational. Acceptable interface types are:
• RS232C Serial I/F Module, DB-25
• IEEE1284 Parallel I/F Module, AMP 57-40360
• Universal Serial Bus Adapter
• Ethernet 10/100 BaseT I/F Module
• RS422/485 I/F Module, DB-9
Connector for external control of print cycle. Also supplies power for
optional accessories - AMP 57-60140
Slot for the insertion of optional PCMCIA Memory Card
FEED KEY
FEED
POTENTIOMETERS
PITCH
DIP SWITCHES
DSW3
MEMORY CARD SLOT
Figure 1-2, Switches, Indicators, and Connection Ports
PN 9001125A
INTERFACE PORT
I/F
EXT PORT
EXT.
POWER POWER SWITCH
MAIN FUSE CONNECTION
FUSE T3.15A H 250V
AC POWER INPUT
100V - 120V
REAR COVER
Page 1-5