Table of Contents
Advertisement
3.6.10
USB Configuration
The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
Legacy USB Support
[Enabled]
Your system supports the USB devices in legacy operating systems.
[Disabled]
Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto]
Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
XHCI Hand-off
[Enabled]
Enables the support for operating systems without an XHCI hand-off
feature.
[Disabled]
Disables the XHCI Hand-off support.
USB Mass Storage Driver Support
This item allows you to enable or disable USB Mass Storage Driver Support.
Configuration options: [Disabled] [Enabled]
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.
3.7
Monitor menu
The Monitor menu displays the system temperature/power status, and allows you to change
the fan settings.
Scroll down to display the other BIOS items.
Q-fan Configuration
Qfan Tuning
Click this item to automatically detect the lowest speed and configure the minimum
duty cycle for each fan.
AIO PUMP/W_PUMP+ Control
[Disabled]
Disable the Water Pump control feature.
[Auto]
Detects the type of water pump installed and automatically switches
the control modes.
[DC mode]
Enable the Water Pump control in DC mode for 3-pin chassis fan.
[PWM mode]
Enable the Water Pump control in PWM mode for 4-pin chassis fan.
ROG CROSSHAIR VII HERO (WI-FI)
3-19
Hide quick links:
Advertisement
Table of Contents
