Connecting To The Lan Line; Network Configuration - Sanyo Projector Owner's Manual

Chapter 2 Setup Procedures
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN line

Connect the LAN cable to the LAN connection terminal of the projector.
* Please use a shielded LAN cable.

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be
made with browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the
settings described in this chapter before performing steps in "3. Basic setting and opera-
tion."
Setting Procedure
1. Select "Network" in the Network menu, and press Point 8 or SELECT button.
2. Select "On" with the Point ed buttons, and the press SELECT button. Then the Menu
will disappear, the "Please wait..." message will appear, and switching operation will start.
Switching will take a while and the projector's LINK/ACT Lamp will be on or blink, and
after completing the operation, the "Please wait..." message will disappear.
1
LAN Connection Terminal
LAN Cable
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.