Table of Contents
Advertisement
Recovering from Power Saving
●
Operation
Press any button, perform a crown operation,
or place the watch in a well-lit area to recover
from power saving.
Auto Time Adjustment
Your watch can receive time calibration
signals and connect with a phone to obtain
information that it uses to adjust its day and
time setting.
Time Adjustment Using a Time
●
Calibration Signal
Your watch automatically receives a time
calibration signal at a specific times each day
and adjusts its time setting. This means its
time setting is always accurate without the
need for any adjustment by you.
Auto Time Calibration Signal Receive
l
Time calibration signal
Note
You can also trigger a time
●
calibration signal receive operation
manually.
Manual Time Calibration Signal
l
Receive
Using a Phone to Adjust the Watch's
●
Time
While the watch is paired with a phone, it will
automatically connect with the phone four
times a day and adjust its time setting in
accordance with the phone time.
Auto Time Adjustment
l
Operation Guide 5526
If the watch is not showing the correct
●
time...
If the watch does not indicate the correct time
even after it receives a time calibration signal
or connects with the phone, adjust the hand
and day indicator positions.
Using MR-G Connected to Make
l
Adjustments
Using Watch Operations to Make
l
Adjustments
Checking the Last Time
Adjustment Result
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Press (B).
The second hand will indicate the last time
adjustment operation result. The watch
hands will return to indicating the current
time if you do not perform any operation
for nine or ten seconds.
[Y(YES)]: Last time adjustment operation
successful.
[N(NO)]: Last time adjustment operation
failed.
Note
Even if there was a successful time
●
calibration signal receive operation
or connection with a phone, the
second hand will point to [N(NO)] if
you adjusted the time setting
manually or if there has been a
change in the day.
Second hand
Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto time
calibration signal receive or connection with a
phone may cause problems, you can perform
the procedure below to disable such
operations. To re-enable auto time
adjustment, perform the same operation
again.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Press (B).
The second hand will indicate the last
receive result for nine or ten seconds.
3.
Within 10 seconds after pressing (B)
above, pull out the crown to the first click.
If more than 10 seconds elapse before
●
you pull out the crown after you press
(B), the second hand will return to
indicating seconds. If this happens,
press (B) again.
4.
Rotate the crown to disable auto time
adjustment.
[Y(YES)]: Auto time adjustment enabled.
[N(NO)]: Auto time adjustment disabled.
5.
Push the crown back in.
Note
If the watch is paired with a phone,
●
MR-G Connected can be used to
disable auto time adjustment.
Using MR-G Connected to Disable
l
Auto Time Adjustment
Crown
5
Advertisement
Table of Contents
