Fitting An Aquamaster Pulsed Output Socket With Serial Communications - ABB CalMaster2 Instruction Manual

Field and Software Tools
CalMaster2 and CheckMaster

3.3.5 Fitting an AquaMaster Pulsed Output Socket with Serial Communications

B
Fig. 3.10 Fitting an AquaMaster Pulsed Output Socket with Serial Communications
To fit an AquaMaster pulsed output socket with serial communications:
1. Turn off the power to the AquaMaster and remove the covers – see Section 3.3.2, page 12.
Disconnect and withdraw the pulsed output cable A.
2.
Remove and discard the gland B.
3.
Feed the socket lead into the AquaMaster and fit the socket (MGFA0609-O) C.
4.
Connect the sensor cable D.
5.
6. Replace the covers – see Fig. 3.7, page 12.
IM/VCM2 Issue 6
O/P COM Grey/Blue
O/P1 Orange
O/P2 Blue
GND Green
RI Yellow
CTS Yellow/Red
RTS Red/Black
TXD Brown
RXD Violet/Red
D
A
3 Installation
C
15