Fitting An Aquamaster Pulsed Output Socket - ABB CalMaster2 Instruction Manual

Field and Software Tools
CalMaster2 and CheckMaster

3.3.4 Fitting an AquaMaster Pulsed Output Socket

D
Fig. 3.9 Fitting an AquaMaster Pulsed Output Socket
To fit an AquaMaster pulsed output socket:
1. Turn off the power to the AquaMaster and remove the covers – see Section 3.3.2, page 12.
Disconnect and withdraw the pulsed output cable A.
2.
Remove and discard the gland B.
3.
Feed the socket lead into the AquaMaster and fit the socket (MGFA0609-S) C.
4.
Connect the sensor cable D.
5.
6. Replace the covers – see Fig. 3.7, page 12.
14
O/P3
O/P2
O/P1
O/P COM
+V
0V
DATA
C
Brown
Red
Orange
Yellow
Violet
Green
Blue
B
IM/VCM2 Issue 6
3 Installation
A