Engine Coolant; Checking The Battery; Window Washer Fluid - Acura RDX Owner's Manual

Hide thumbs Also See for RDX:
Table of Contents

Advertisement

MAINTENANCE
Models with Multi-Information Display
1. Set the power mode to ON.
2. Press the right selector wheel until the content is displayed.
3. Roll the right selector wheel until the Maintenance screen is displayed.
4. Press and hold the right selector wheel for about 10 seconds to enter
the reset mode.
5. Roll the right selector wheel to select the maintenance item to reset.
6. Press the right selector wheel to reset the selected item.
Failure to reset the engine oil life after a maintenance service results in the
system showing incorrect maintenance intervals, which can lead to serious
mechanical problems.

Engine Coolant

Park the vehicle on level ground. Check the reserve tank and the coolant level
in the radiator. Use Acura Long Life Antifreeze/Coolant Type 2
Checking the Reserve Tank
n
1. Open the hood. (see Opening the Hood) Check the amount of coolant
in the reserve tank.
2. If the coolant level is below the MIN mark, add the specified coolant
until it reaches the MAX mark.
3. Inspect the cooling system for leaks.
For vehicles used in temperatures below -31°F (-35°C), change the coolant
from the standard 50:50 antifreeze:water mix to one with added
antifreeze. Consult a dealer for more information.
n
Adding Coolant
1. Make sure the engine and radiator are cool.
120 |
2. Turn the radiator cap 1/8 turn counterclockwise and relieve any
pressure in the coolant system.
3. Push down and turn the radiator cap counterclockwise to remove it.
4. The coolant level should be up to the base of the filler neck. Add
coolant if it is low.
5. Put the radiator cap back on, and tighten it fully.
Removing the radiator cap while the engine is hot can cause the coolant
to spray out, seriously scalding you.
Always let the engine and radiator cool down before removing the
radiator cap.
Pour the fluid slowly and carefully so you do not spill any. Clean up any
spills immediately; they can damage components in the engine
compartment.

Checking the Battery

The battery condition is monitored by the sensor on the negative terminal. If
there is a problem with the sensor, a warning message appears on the Multi-
Information Display. Have your vehicle checked by a dealer.
The battery gives off explosive hydrogen gas during normal operation.
A spark or flame can cause the battery to explode with enough force to kill or
seriously hurt you.
When conducting any battery maintenance, wear protective clothing and a
face shield, or have a skilled technician do it.
WARNING: Battery posts, terminals, and related accessories contain lead and
lead compounds. Wash your hands after handling.

Window Washer Fluid

Check the amount of window washer fluid by looking at the reservoir. Fill if it
is low. Pour the washer fluid carefully. Do not overflow the reservoir.
Canadian Models Only
If the washer fluid is low, a message appears on the Multi-Information Display
MAINTENANCE
| 121

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents