Qomo QD700 Manual page 9

Rear Panel
OUT
OUT
IN IN
AUDIO VIDEO S-VIDEO AUDIO VIDEO S-VIDEO
AUDIO
Note: You can connect a laptop computer to the RGB IN port of side
panel with a RGB cable.
Step 4: Connect to the first video equipment with S-Video input.
S-Video out
Video equipment
Projector
(or amplifier/speaker equipment)
Audio input
Output of the S-Video signal from the visualizer to the projector is
already done in the step 2, where the RGB cable comes out from the
visualizer and goes to the projector. After the connections as steps 2,
3, 4 are made, input signals from the computer、visualizer CCD and
S-Video are going to the RGB1 input on the projector and will be
displayed on the projector screen as RGB1. These signals can be
seen in turn when pressing "CCD/PC1/PC2" and "S-VIDEO/VIDEO"
on the control panel of the visualizer.
Remarks: RGB IN signal can not go to S-VIDEO OUT or VIDEO
OUT port to be displayed on the screen.
PROJECTOR OUT -COMPUTER- IN OUT-12V- IN
AUDIO IN
Audio out
To the
Monitor
RGB Output
Computer
S-Video Cable
OUT OUT IN
AUDIO
VIDEO S-VIDEO VIDEO
AUDIO
9
USB Connector
RS232
Cable
PROJECTOR MIC USB RGB IN
Side Panel
Rear Panel
IN
S-VIDEO
AUDIO AUDIO IN OUT -COMPUTER-
PROJECTOR
AUDIO IN
RS232
OUT-12V- IN
IN