How To Install The Wired Remote Controller (Optional Part); Installation Site Selection - Sanyo CH2442 Installation Instructions Manual

6. HOW TO INSTALL THE WIRED REMOTE CONTROLLER
(OPTIONAL PART)

6-1. Installation site selection

Install the remote controller at a height of between
3–5 ft. above the floor.
Do not install the remote controller in a place where
it will be exposed to direct sunlight or near a
window or other place where it will be exposed to
the outside air.
Be sure to install the remote controller vertically,
such as on a wall.
The mounting position for the remote controller
should be located in an accessible place for control.
Never cover the remote controller or recess it into
the wall.
Mounting dimensions for continuous installation
When mounting the remote controller on a wall,
please see Fig. 6-1 and Fig.6-2.
3-21/32 in. or more
(from wall)
Spacer
3-17/32 in. or more
Wall
(from wall)
Hole for routing
remote control
cable
JIS CB8340
One switchbox
(no cover)
Spacer
3-17/32 in. or more
Wall
(from wall)
Hole for routing
remote control
cable
JIS CB8340
Two switchbox
(no cover)
45 S4359146
4-29/32 in. or more
(during continuous
installation)
4-29/32 in. or more
(during continuous
installation)
3/32 in.
(amount offset from JIS box)
1987_C_I
Fig. 6-1
4-29/32 in. or more
(during continuous
installation)
1988_C_I
Fig. 6-2
6 6 6 6 6
RC
(WD)