Remote Control Unit - Sanyo RCS-SH80UA Instruction Manual

F: FILTER reset button
G: CHECK button
H: UNIT button
I: FLAP button
1
.
J: TIMER SET button
K: Time setting buttons
L: SET button
M: CL button
N: Temperature sensor of the
remote controller
O: VENTILATION button
1 - 6
Remote Control Unit (continued)
Use this button to reset the filter sign
for the filter and informs you when the filter needs cleaning.
This button is used only when servicing the air conditioner.
Do not use the CHECK button for normal operation.
When more than one indoor unit is connected, this button is used to
select a unit when adjusting the airflow direction.
If no unit is selected, the airflow direction of all units can be adjusted
concurrently using the FLAP button.
( ) 1. Use this button to set the airflow direction to a specific angle.
The airflow direction (
Operation mode
• In the cool mode and dry mode, when the flaps are set in a
• Do not move the flap with your hands.
This function is available only for models X and T.
NOTE
( ) 2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the (
the display.
This function is available only for models X, T and K.
NOTE
Use this button while the unit is operating to switch between timer
settings:
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
Use this button to set the timer.
Use this button to clear the timer setting.
While the temperature sensor of the indoor unit usually detects ambient
temperatures, it is also possible to detect temperatures around the
remote controller. For the detail of this functionality, consult your dealer.
(Do not use this functionality for group operation.)
Use this button when you installed a fan available in the market.
Pressing this button turns on and off the fan.
When turning off the air conditioner, the fan will be also turned off.
While the fan is operating,
displayed when pressing the ventilation button, no fans are installed.
) is displayed on the remote control unit.
Number of airflow direction settings
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
downward position, condensation may form and drip around
the vent.
:The air conditioner stops after the length of time set.
:The air conditioner after the same set time every time.
:The air conditioner starts after the length of time set.
:Press this button to increase the time.
:Press this button to decrease the time.
will appear in the display. If
. The air conditioner has a timer
3
5
3
5
) symbol appears on
is
OI-432-01 - 6EG