When Setting The Program Operation Erroneously - Sanyo RCS-SH80UA Instruction Manual

6.

When setting the program operation erroneously

If the ERROR indicator
correct times you set.
1 While the
2 Press the SET button to make the time to be corrected blink.
3 Correct the time using the HH or/and MM button.
4 Press the SET button. If the corrected time is acceptable, the
5 Press the PROGRAM button to complete the correction.
NOTE
Programming shown below will cause ERROR setting.
(1) Programmed operation periods overlap between programs.
(2) The OFF-time is earlier than the ON-time.
(3) The OFF-time and ON-time is the same.
(4) Only the ON-time or OFF-time is programmed.
The following examples will not cause ERROR setting.
(1) The OFF-time is the same with the ON-time of the subsequent operation period.
3
(2) The programmed period is earlier than the preceding period.
(3) Both the ON-time and OFF-time are 0:00.
3 - 10
blinks while you are setting program operation, take the following steps to
blinks, the ON-time of the program operation that is incorrectly set also blinks.
Example: ON-time OFF-time
Example: ON-time OFF-time
Example: ON-time OFF-time
Example: ON-time OFF-time
(not programmed)
Example: ON-time OFF-time
Example: ON-time OFF-time
By pressing the PROGRAM button, programs are arranged in order of time.
Example: ON-time OFF-time
Example: ON-time OFF-time
turns off.
0:00
ON OFF
ON
0:00
OFF ON
0:00
ON/OFF
0:00
ON
0:00
ON OFF
ON
0:00
ON
ON OFF
* This program is for 24-hour
continuous operation.
23:59
OFF
23:59
23:59
23:59
23:59
OFF
23:59
OFF
OI-432-03 - 10EG