Sanyo C4272R S/C Installation Instructions Manual page 93

07-115 SSHP_II 5/7/07 4:00 PM
(c) Automatic zone registration using the system
controller (SHA-KC64UG)
(1) Press the
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE No. C2 by pressing
( ) button and press the
C2 changes from flashing to ON state and
automatic zone registration will start.
(3) Any registered GROUP Nos. will be erased.
(4) Central address will be assigned from the smallest
indoor unit address to larger ones in numerical
order automatically.
On finishing automatic zone registration,
changes from flashing to OFF.
(5) If an error occurs, "CHECK" starts
flashing and zone registration finishes at this
time. Press the
(6) Finally, complete automatic zone registration
mode by pressing the
flashes for a few minutes, then turns OFF.
Page 93
and buttons at the same
and
button.
button to start over.
button.
Fig. 8-10
93
SC