Sanyo C4272R S/C Installation Instructions Manual page 92

07-115 SSHP_II 5/7/07 4:00 PM
(b) Zone registration using the system controller
(SHA-KC64UG)
In this case, you set all central addresses by
the system controller at once manually.
(1) Press the and
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) After confirming that CODE No. C1 is displayed,
press the button. Once in this mode, a
change takes place as shown in Fig. 8-8.
(3) Select the zone and group No. you want to
set with
ZONE
buttons.
If already set, press the
(4) Set the unit No. (indoor unit address) with
and buttons, according to the zone registra-
tion table.
R.C. No. ...................
Indoor unit No. ..........
(5) Press the
GROUP No. turns ON and UNIT No. (indoor unit
address) changes from flashing to ON state.
UNIT No. is registered to the selected ZONE No.
and GROUP No.
If you make a mistake, press the
and reselect the ZONE, GROUP and UNIT No.
(6) Register the other UNIT Nos. in the same way by
following steps (3) to (5).
(7) Finally, complete the registration by pressing the
button.
flashes for a few minutes, then turns OFF.
SC
Page 92
buttons at the same
ZONE
and (GROUP)
buttons.
button
button
button.
button
ZONE
1 2 3
ZONE
9
If data is
registered
the unit No.
is displayed.
SELECT ZONE
Fig. 8-8
ZONE 1 2 3
ZONE
9
SELECT ZONE
For example, in this case
Zone 3, Group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to Zone 3, Group 7.
Fig. 8-9
92
If no data is
registered
no number is
4 6
displayed.
Selected group
No. if no data is
registered.
GROUP
4 6 7
GROUP