Operation With The Remote Control Unit; Manual Operation - Sanyo C0951 Technical & Service Manual

1. Manual Operation

NOTE
12
Operation with the Remote
Control Unit
TIMER
STEP 2
STEP 4
Check that the circuit breaker on the power panel is turned on and that the
operation selector of the indoor unit is in the ON position.
If the automatic operation settings of the unit do not meet your needs,
press the setting buttons as described below and change the settings as
desired.
STEP 1 Press the MODE selector button and select the desired
mode.
For drying operation
For cooling operation
STEP 2 To start
operation button.
STEP 3 Press the temperature setting buttons to change the
temperature setting to the desired temperature.
Adjustable temperature range:
The temperature setting changes by one degree each
NOTE
time the
remembers the new temperature setting even when it is
turned off.)
STEP 4 Press the FLAP button and set the airflow direction as
desired.
(Refer
page 18.)
To stop the air conditioner, press the ON/OFF operation button again.
SET TEMP.
ON
1HR.
TEMP.
OFF
FLAP FAN SPEED MODE
ON OFF
NIGHT
SET CANCEL SETBACK
the air conditioner,
button is pressed.
to ''Adjusting the
STEP 3
STEP 1
press the ON/OFF
88 °F max.
60 °F min.
(The air conditioner
Airflow Direction'' on
OI-330-12EG