Advertisement
.
2.
WARNING
Do not attempt
to use a cylinder
with any other type of connection
device.
Do not attempt
to use a cylinder
with a larger capacity
LP CYLINDER
FILLING
AND
EXCHANGE
Some areas only allow you to exchange
your empty cylinder
tbr a replacement
that is already
full.
Other areas
allow you to refill your cylinder.
If you are in an area where you can refill your cylinder:
1.
Use only a licensed
dealer.
2.
The dealer must first purge
a new cylinder
before filling.
3.
Never
fill a cylinder
more than 80% lull by volume.
Volume
will vary by temperature.
An empty
cylinder
weighs
approximately
18 pounds
(8.2kgs).
A full one approximately
38 pounds
(17.3kgs).
4.
Be sure the LP dealer checks
the cylinder
_br leaks after filling.
5.
Do not release
LP gas into the atmosphere,
as it can unexpectedly
ignite when mixed
with air.
6.
Contact
a LP dealer to remove
LP gas from a cylinder.
Only exchange
your cylinder
tbr one with an O.P.D.
feature
as shown
above.
WARNING
A _osty
cylinder
valve
indicates
possible
gas overfill.
Close
the LP valve and call your dealer
immediatelv.
WARNING
1. Never
store any extra cylinders
near your grill.
2.
Keep cylinders
out of direct
sunlight
and high heat.
3.
Never
fill your cylinder
over 80% full by volume.
This may cause release
of gas t_Oln the safety
release
valve.
4.
Ilnmediately
call your LP dealer or fire department
should
you hear, smell, or see escaping
gas
/_Oln the cylinder.
5.
Do not insert any type of foreign
objects
into the valve
outlet.
The gas supply
must be turned
off at the LP-
gas supply
cylinder
when this outdoor
cooking
gas appliance
is not in use.
L'alimentation
du gaz doit _tre fermde
a la bouteille
de gaz de pdtrole
liqudfie,
lorsque
cet appareil
de
cuisson
extdrieur
u'est
pas utilise.
LP CYLINDER
LEAK
TEST
A leak test should
be done each time a cylinder
is refilled
or exchanged.
Do
not smoke
or use any type of flammable
material
in the area during
this leak test.
Do not use an open flame to check [br leaks.
1.
Test outside
in a well ventilated
area.
2.
Use a paintbrush
and a solution
of 50% liquid soap and 50% water.
Do
not use cleaning
agents
and they can damage
the fuel supply
parts.
3.
Brush
liquid onto areas highlighted
with arrows.
4.
Bubbles
indicate
a leak.
17
Advertisement
