Table of Contents
Advertisement
4.1 BIOS and boot agent settings
The BIOS and boot agent of the single board computer (SBC) gets pre-configured at the factory. If there is any-
how the need to access one of them some hardware configuration must be done.
There exist multiple versions of the single board computer.
The current version is the SBC/2. It can be recognized by its usage of two slot plates, please refer
also to section
Its predecessor is the version SBC 566 MHz. It uses just one slot plate. It reports during startup
566 MHz processor speed.
4.1.1 Entering the BIOS or boot agent
To access the BIOS, the SBC must be connected to a monitor and a keyboard, therefore follow the steps below:
•
Halt the H
C
YDRA
OMPACT
of it, see section
3.3.3 Switching
•
Connect a monitor to the VGA connector [2] of the single board computer and a PS/2 keyboard to the PS/2
keyboard/mouse connector [6] of the single board computer, see section
•
Switch on the H
YDRA
•
Keep the DEL key of the keyboard pressed until the BIOS setup has started. If the DEL key was pressed too
late and the possibility to enter the setup has passed, restart the H
CTRL ALT DEL.
•
To enter the boot agent setup of the SBC/2 press keep the SHIFT- and F10 key of the keyboard pressed until
the boot agent setup is started.
4.1.2 BIOS settings
The table below lists the H
path
Advanced BIOS Feature -> First Boot Device
Advanced BIOS Feature -> Second Boot Device
Advanced BIOS Feature -> Third Boot Device
Advanced Chipset Features -> Frame Buffer Size
Advanced Chipset Features -> Panel Type
Integrated Peripherals -> Primary Master PIO
The table below lists the H
566 MHz processor speed:
path
Inside Utilities -> Display Setup -> Embedded VGA/LCD/TV Type
Inside Utilities -> Display Setup -> Set Panel Type
Barco – Hydra Compact – R5976568 – Revision 12 – May-2005
3.2.2 Single board
computer.
. When the H
C
YDRA
OMPACT
off.
C
by pressing the power switch [5] of the H
OMPACT
specific BIOS settings that must be selected for proper operation of the SBC/2:
YDRA
specific BIOS settings that must be selected for proper operation of the SBC with
YDRA
____________________________________________________________________________________________________
has halted, switch it off by the power switch [5] on the front
YDRA
C
YDRA
OMPACT
setting
CDROM
LAN
Floppy
32M
06
Mode 3
setting
CRT1 + LCD
1280x1024
TFT Color
IBM
ITSX94
4. Operating
3.2.2 Single board
computer.
C
again.
OMPACT
with the key combination
BIOS settings of SBC/2
BIOS settings of SBC 566 MHz
Table 4-1
Table 4-2
4-2
Advertisement
Table of Contents
