PART NO. CRPWREXH030A01, CRPWREXH021A01, CRPWREXH022A01,
CRPWREXH023A01, CRPWREXH080A00, CRPWREXH081A00
FOR USE WITH VERTICAL ECONOMI$ER
TABLE OF CONTENTS
SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . .1
PACKAGE CONTENTS AND USAGE . . . . . . . . . . . . .1
GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
EconoMi$er X. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
IMPORTANT: Read entire instructions before installing
the accessory.
SAFETY CONSIDERATIONS
Installation and servicing of air-conditioning equipment can
be hazardous due to system pressure and electrical components.
Only trained and qualified service personnel should install, re-
pair, or service air-conditioning equipment.
Untrained personnel can perform basic maintenance func-
tions of cleaning coils and filters and replacing filters. All other
operations should be performed by trained service personnel.
UNIT CONFIGURATION
Small Cabinet
Large Cabinet
Extra Large Cabinet
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53480206-01
Installation Instructions
ECONOMI$ER
Table 2 - Package Usage
UNIT FOOTPRINT (IN.)
46
3
/
x 74
3
/
4
8
58
1
/
x 88
1
/
2
8
66
3
/
x 115
7
/
8
8
Printed in U.S.A.
Gas Heating/Electric Cooling,
Electric Cooling, and Heat Pump Units
3 to 15 Tons Small Rooftop Units
Vertical Power Exhaust Accessory
®
IV, ECONOMI$ER
®
X ONLY
When working on air-conditioning equipment, observe precau-
tions in the literature, tags and labels attached to the unit, and
other safety precautions that may apply.
Follow all safety codes, including ANSI (American National
Standards Institute) Z223.1. Wear safety glasses and work
gloves. Use quenching cloth for unbrazing operations. Have fire
extinguisher available for all brazing operations.
Electrical shock can cause personal injury and death. Shut
off all power to this equipment during installation. There
may be more than one disconnect switch. Tag all discon-
nect locations to alert others not to restore power until work
is completed.
PACKAGE CONTENTS AND USAGE
See Tables 1 and 2 for package content and usage.
Table 1 - Package Contents
QTY
1
Power Exhaust Hood/Fan Assembly
Low Voltage Wiring Harness with plug and 12-in. (305
1
mm) gray jumper wire
1
High Voltage Wiring Harness with plug
8
No. 10 x
1
Gasketing Roll
1
Sealing Angle
NOTES:
1. Both wiring harnesses are shipped attached to the power
exhaust assembly.
2. The sealing angle was included beginning with unit serial num-
bers 3502Gxxxxx (21A-23A and 30A power exhaust only). For
use with Hinged Panel units only.
POWER EXHAUST PART NUMBER
CRPWREXH030A01
CRPWREXH021A01
CRPWREXH022A01
CRPWREXH023A01
CRPWREXH080A00
CRPWREXH081A00
Form IIK-CRPWREXH021-07 Pg 1
®
2, OR
WARNING
CONTENTS
1
1
1
3
/
in. (19 mm) Mounting Screws
4
2
POWER EXHAUST VOLTAGE
208/230 V, 1 Ph
460 V, 3 Ph
208/230 V, 1 Ph
460 V, 3 Ph
208/230 V, 1 Ph
460 V, 3 Ph
8-18
Replaces: IIK-CRPWREXH021-06