Cisco GR10-HW Manual page 9

Power the GR10-HW
If mounting to an electrical junction box, feed the Ethernet cable through the cable access
hole in the mount cradle. If mounting to a wall or ceiling, the Ethernet cable will feed from
behind the GR10-HW. The "Power Source Options" section of this document lists the
different powering options and their unique characteristics.
Mount the GR10-HW
Attach the GR10-HW to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount
where you have already installed the mount cradle.)
The GR10-HW attaches to the mount cradle with two tabs on the cradle that insert into the
GR10-HW, and is secured to the cradle using one screw.
To attach the GR10-HW to the mount cradle properly, line up the top edge of the AP with the
top tab of the mount cradle. Since the cradle is already mounted to the wall, guide the GR10-
HW towards the top tab and insert the top tab into the GR10-HW's slot.