5.6 5.8 GHz Specific Frequency Planning Considerations
Adjustment of the lower center frequency allows the operator to slide the available frequency
settings up and down the 5.8 GHz bands.
Figure 13 5.8 GHz Available Spectrum Settings – 15 MHz Channel Bandwidth
5.6.1 5.8 GHz Raster Considerations
The PTP 300 Series Bridge 5.8 GHz variant operates on a 5 MHz channel raster. The channel
raster is set to even center frequencies. See
5.6.2 5.8 GHz Transmit Power Reduction at the Band Edges
Operation at or near the 5.8 GHz band edges can results in a lower maximum transmit power.
In some configurations the PTP 300 Series Bridge solution reduces the power when operating at
the edge channels. The amount of reduction, if any, is dependent on the region code of the region
of operation. This currently only affects systems configured with Region Code 1. The power
reduction in the edge channels for 15 MHz is presented in
General Considerations
Figure 13
shows the available spectrum.
Figure
13.
Table 6
40
(for region code 1 ONLY).