Fig:using Dvm For Alignment - Motorola PTP 300 Series User Manual

Installation
is proportional to the receive signal strength. To use remove the protective cap frome the case
mounted BNC connector and connect a DVM.Yo may have to invert the pole for correct reading.
Figure 24 shows the relationship between measured values and the receive signal strength.
Figure 24 fig:Using DVM For Alignment
6
When the alignment process is complete the installer MUST REMEMBER TO DISARM BOTH
UNITS in the link as described in Section 8.3.4 "Install Pages". This is necessary in order to:
• Turn off the audible alignment aid
(Section 8.3.4.4 "Disarm")
• Enable Adaptive Modulation
• Fully enable Advanced Spectrum Management with i-DFS
• Clear unwanted installation information from the various systems statistics
• Store the link range for fast link acquisition on link drop
• Enable higher data rates
6
After 24 hours, the units will be disarmed automatically provided that they are armed and that the link is UP.
58