Zero Calibration - A&D AD-4329A Instruction Manual

5.2.6. Zero Calibration

Step 7 Check the
Select a zero calibration method to adjust the zero point
Weighing input
(Normal way)
Digital input
Weighing Input
Step 8 Place nothing on the weighing unit. Press the
after the MD mark has turned off. Proceed to step10.
key..... The key not to change the zero point
MODE
Caution Do not press the
(detecting motion). Arrange the condition using
the F00 filter function.
Digital Input
Step 9 Pressing the
of the zero point is displayed in the unit of mV/V. Adjust
the input voltage using the following keys.
key ........ The key to select a figure.
key ........ The key to select a number.
key ........ The key to store the zero point parameter
key... The key not to change parameter and
MODE
AD-4329A Weighing Indicator
display.
Cal 0
The adjustment method
with nothing on the
weighing unit.
The numerical input to
enter a load cell output
voltage.
data and proceed to step 10.
key while the MD mark is lit
key, a stored input voltage parameter
M+
and proceed to step 10.
proceed to step 10.
To step 8
To step 9
key
Page 15
5. Calibration