Table of Contents
Advertisement
3
3
CHAPTER 3
Setting up and connecting
If you connected your TV using RGB/DVI or YP
9
select RGB/DVI or YP
(Optional) follow the instructions on the next page if you have a VCR and
10
want to hook up the VCR control.
Plug in the power cords for your TV, A/V receiver, and DIRECTV
11
Setting your TV input button
To view any of the programming from your DIRECTV
off-air), set your TV to display the input from the video input jack you used to connect the
DIRECTV
HD Receiver. (This is a setting on your TV usually controlled by a Video, Input,
®
or Mode button. See your TV manual for help.)
Also, if necessary, set your A/V receiver to play the audio from the audio input jack you
used to make the audio connection. See your A/V receiver manual for help.
Connecting the RF remote cable with RF receiver.
You can operate the Digital Satellite Receiver when installed in a cabinet or from another
room in your house using the RF remote control. (Optional)
Connect the RF Receiver to the RF REMOTE jack of the Digital Satellite Receiver.
1
NOTE
The operating range of the remote control is about 100 feet when connecting the RF receiver.
This may decrease due to ambient reception conditions, weak batteries, obstacle, etc...
B
P
output mode.
B
R
P
output, press the output mode button to
R
HD Receiver.
®
HD Receiver (satellite, cable, or
®
Advertisement
Table of Contents
