Samsung DIRECTV SIR-TS160 Owner's Manual page 39

Chapter 3: Setting up and connecting
If this screen is not displayed, access the Main Menu by pressing the MENU
button on your remote control. Then use the arrow buttons on your remote
control to highlight the Setup menu, and press the OK button. Then highlight
the Installation menu, and press the OK button.
The Installation menu appears.
2
Highlight the Set Dish menu item, then press the OK button.
The Set Dish menu appears.
3
Highlight the Select Dish Type menu item, then press the OK button.
The Select Dish Type screen appears.
4
Use the right-arrow button on your
remote control to highlight the
Dish Type option on the Select Dish
Type screen.
5
Use the up- and down-arrow
buttons on your remote control to
display the dish type you are using
(Round, Oval-2, Oval-3, or No Dish).
As you display each dish type, the on-screen pictures update showing you what
each of these dish types look like.
If you plan to use your DIRECTV
cable TV programs, but do not plan to receive DIRECTV
No Dish.
6
When you have displayed the correct dish type, use the right-arrow button on
your remote control to highlight the on-screen OK button, then press the OK
button.
A message appears warning you that
your DIRECTV HD Receiver needs to
reboot (turn itself off and on) for the
Dish Type setting to take effect.
7
To change the Dish Type to the new
setting, highlight the on-screen OK
button, then press the OK button.
To leave the Dish Type setting
unchanged, highlight the
on-screen Cancel button, and press
the OK button.
After you select the on-screen OK button, the DIRECTV HD Receiver will reboot.
If you selected No Dish, the DIRECTV HD Receiver will perform an auto-scan to put
your cable and off-air channels into its memory so you can tune them and see them
in the on-screen Guide.
®
High-Definition Receiver for local off-air or
®
programming, select
32