Horizon Fitness FCJJ-34 Assembly Manual

ASSEMBLY GUIDE
Fuel Cell Science Education Kit
Model No.: FCJJ-34
Warning
To avoid the risk of property damage, serious injury or
death:
1. Read carefully and fully understand the instructions
before assembling this kit.
2. Keep this kit out of reach of small children and
animals because it contains small parts that could be
swallowed.
3. This product is intended only for use by persons
aged 12 years and older, and only under the supervi-
sion of an adult who has read and understood the
instructions provided in this user manual.
List of Components
a. Salt water fuel cell
b. Salt water fuel cell anode plate
c. Fan module
d. Salt water fuel cell base
e. Fan blade
f. Graduated container
g. Wires (two 20cm long & one of 10 cm)
h. Fan blades adapter
i. Syringe and syringe tubing
You will also need the following items (not included in this kit):
- Purified or distilled hot water at a temperature at or above 90°C
- Salt (food grade) 50g
- Weighing scale/balance
4. You may use tools to assemble this kit, however,
extra care should be taken to avoid injury.
5. Some parts are small and fragile. Please be careful
when handling and connecting parts to avoid
breakage. Handle all parts and components with care.
6. Do not attempt to use any part, item or components
provided in this product for any purposes other than for
its intended use.
7. Do not attempt to disassemble any parts, items or
component in this kit.
a
b
d
e
f
h
g
i
1
IMPORTANT NOTES:
1. To avoid injury please take care with the hot water.
2. Wearing waterproof gloves and glasses is strongly recommended.
3. To avoid injury please take care with the fan.
4. To maximize the kit's longevity, clean the anode plate after each use
5. Store the anode plate in a clean, dry place.
Preparing the saltwater solution:
1. Weigh 15 mg of salt using the scale. Put the salt in the graduated container and add 25ml of hot water.
The water temperature should be around 90°C (363 K).
2. Mix the container's contents with a spoon until the salt has entirely dissolved into the water. Sometimes
a small part of the salt stays in a solid state.
Experiment 1 : Create electricity from saltwater
Prepare the fuel cell:
a. Take the salt water fuel cell out of the packaging.
b. Note that the blue plastic top of the saltwater fuel cell plate extends below the lip of the saltwater fuel cell
tank. Squeeze both these blue sections at the same time to remove the SWFC plate from the SWFC tank.
c. Insert the fuel cell cathode into the slot in the base of the SWFC tank.
d. With the syringe, suck up some of the saltwater solution and transfer it to the SWFC tank until the tank is
about ¾ of the way full (above 15mL).
e. Take the SWFC plate and clip it into the SWFC tank as shown below.
c
2