Ethernet Menu; General Setup Menu - NETGEAR RM356 - Router - EN Reference Manual

Ethernet Menu

Menu 3 is for configuring the Ethernet LAN parameters, including interface type, filters, DHCP,
and IP address information. From the Main Menu, enter 3 to display Menu 3 - Ethernet Setup.
There are two submenus: Menu 3.1 - General Setup and Menu 3.2 - TCP/IP and DHCP Setup.
Refer to the following sections for descriptions of these submenus. Refer to
for information about navigating through the menus.

General Setup Menu

The General Setup Menu allows the application of filter sets for filtering your Ethernet traffic.
Filter sets are used to block certain packets in order to reduce bandwidth or to enhance security.
Refer to Chapter 8, "Filter
Filters that have been defined in Menu 21 may be applied here by entering their numbers in the
appropriate fields in this menu. Up to four filter sets may be cascaded by listing the filter set
numbers separated by commas.
Table 3-5 lists and describes the filter sets in the Ethernet General Setup menu.
Table 3-5. Ethernet General Setup Menu Filter Sets
Field
Input and Output Filter
Sets
Router Configuration
Reference Guide for the Model RM356 Modem Router
Configuration," for more information about configuring filters.
Description
Enter the filter set number(s) to apply a filter to packets received from the LAN
(Input) or sent to the LAN (Output).
Table 3-1 on page 3-3
3-9