Operating Instructions; Sunfi Re 200 Solid State Control With; Electromechanical Timer; In Off Mode - Garland SCO-ES-20S Installation, Operation And Maintenance Manual

OPERATING INSTRUCTIONS

Sunfi re 200 Solid State Control with

Electromechanical Timer

In Off Mode

When the oven is off , there are no lights or indicators.

Start Up

Press the Cook/Off /Cool Down rocker switch to the "Cook"
position. The green lamp will light indicating the oven is
powered in cook mode.
The oven will begin to heat to the temperature set on the
thermostat dial. The amber lamp will light indicating the heat
is active. As the heat cycles on and off to maintain the set
temperature this light will go on and off accordingly.
The door must be closed for the oven to operate in cook
mode. Opening the door will cause the heat to stop and the
motor and fan will shut off . This is a safety feature.

Fan Speed Selection (If equipped)

The fan speed can be either high (1725 RPM) or low (1140
RPM). The fan speed is controlled by the left rocker switch
marked high and low.

Single Fan Speed

Single speed units operate at high (1725 RPM) only and do
not have a fan speed switch on the control panel.

Lights (If equipped)

The oven lights are activated by pressing the light switch
on the control panel. This is a momentary switch and the
lights will only stay lit as long as this button held in the on
position. Lights will work whenever there is electrical power
connected to the oven. Unit not equipped with lights do not
have a light switch on the control panel

Cool Down

Pressing the Cook/Off /Cool down rocker switch to the Cool
down position activates the fan and motor to cool the oven
cavity. The door must be open slightly for the fan and motor
to start. The heat is not active in this mode.
Optimal cool down will be achieved with the door open
slightly. Opening the door too far will shut the fan and motor
off . This is a patented safety feature.
Pressing the button to the OFF position cancels the cool
down and turns the oven off .

Temperature

The temperature range is from 150° to 500°F (66°ºC to 250ºC)
is controlled by rotating the temperature dial and aligning
the indicator to the desired temperature.
Part Number 4530589 rev B 4/15

Timer

The timer is set by rotating the dial clockwise aligning the
indicator to the desired time cycle. The timer will count down
from 2 minutes to 60 minutes. At the end of the timing cycle
the buzzer will sound. The buzzer is turned off by rotating the
dial counter-clockwise to the off position as shown on the
control panel.
NOTE: The timer does not control heating.
325
300 350
275 375
250 400
225 425 225
200 450 200
175 475
150F° 500
TEMP
0
5
OFF
10
60
15
55
20
50
25
45
30
40 35
TIMER
Single Speed Two Speed Motor
Motor Control Control Panel
Panel
(Optional)
Standard on
SCO-ES-10S/20S
Models
325
300 350 300
275 375 275
250 400 250
425 225
450 200
175 475 175
150F° 500 150F°
TEMP
0
5
OFF OFF
10
60 60
15
55 55
20
50 50
25
45 45
30
40 35
TIMER
Two Speed Motor
Control Panel with
Oven Interior Light
(Optional)
325
350
375
400
425
450
475
500
TEMP
0
5
10
15
20
25
30
40 35
TIMER
9