Installation; Checking The Package Contents - Samsung C4303(P) Owner's Instructions Manual

In Setup Menu Mode
- UP/ DOWN buttons: Use to move the cursor up or down.
- LEFT/ RIGHT buttons: Use to move the cursor left or
right, or to sequentially view the values that can be
assigned to a parameter.
- ENTER button: Use to select a Sub Menu item, and to
accept the current value.
ZOOM/ FOCUS REMOTE terminals
Use to control ZOOM/ FOCUS from an external controller.
Depending on the input conditions, the terminals can be
set to 4 different modes.
(Operating Voltage Range : +3V ~+13V, -3V~-13V)
Tele
Code Item
-6V
A
B -6V
+6V
C
D
+6V
Caution : In the event of a simultaneous input of RS485 and
wired remote control signal, whichever was input first
will be activated.
(For a camera with the ROM version 1.2 or above,
please refer to page 33.)
ALARM OUT terminal
An alarm signal is output from this terminal when the
MOTION DET mode is activated or BW mode is activated.
(Open Collector DC24V 40mA Max)
:
VIDEO OUT terminal
Connect the monitor's VIDEO IN. The video signal from
the camera is transmitted to the monitor via this terminal.
RS485 terminal
RS485 remote control terminal.
Power LED
Lights when power is on.
POWER IN terminal
Plug in the power adapter here.
7
Wide Near
Far
+6V -6V
+6V
+6V +6V
-6V
-6V -6V
+6V
+6V
-6V -6V
3

Installation

Before Installation

Checking the Package Contents

Make sure that the following accessories are included in
the package.
SCC-C4201(P),C4203(P),
C4301(P),C4303(P)
Mount Adapter
Screw (2)
Terminal Block
E
User's Guide
8