Checking The Water Dispenser Line - Samsung RSG5 User Manual

ChECKing thE watEr DisPEnsEr LinE

A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote
better health, the Samsung water filter removes unwanted particles from your water. However, it does not
sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal
conditions, a 170 cc paper cup can be filled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster
pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer(or fridge) drawer.
Parts for water line Installation
Water line fixer
1
and screws
Connecting to the water supply line
1. first, shut off the main water supply line.
. locate the nearest cold, drinking water line.
. follow the Water line Installation Instructions
in the installation kit.
Close Main
Water pipe
. After connecting the water supply to the water filter, turn your main water supply
back on and Dispense about l to clear and prime the water filter.
1_ setting up
Pipe connector
W ater line
 
C lip W ater filter
 
CAUTION
The water line must be connected
to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the
purifier to malfunction.
Close Main
No gap
Water pipe