Display Settings - Kenwood KDC-153R Instruction Manual

AUDIO SETTINGS
[BASS BOOST] [LV1]/[LV2]/[LV3]: Selects your preferred bass boost level. ;
[OFF]: Cancels.
[LOUDNESS] [LV1]/[LV2]: Selects your preferred low and high frequencies boost to
produce a well-balanced sound at a low volume level. ; [OFF]: Cancels.
[SUBWOOFER SET] [ON]: Turns on the subwoofer output. ; [OFF]: Cancels.
[LPF SUBWOOFER] [THROUGH]: All signals are sent to the subwoofer. ; [85HZ]/[120HZ]/
[160HZ]: Audio signals with frequencies lower than 85 Hz/120 Hz/
160 Hz are sent to the subwoofer.
[SUB-W PHASE] [REVERSE] (180°)/[NORMAL] (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
• Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].
[FADER] [R15] to [F15] ([0]): Adjusts the rear and front speaker output balance.
[BALANCE] [L15] to [R15] ([0]): Adjusts the left and right speaker output balance.
[VOLUME OFFSET] For AUX: [–8] to [+8] ([0]) ; For other sources: [–8] to [0]: Presets the
initial volume level of each source.
(Before adjustment, select the source you want to adjust.)
[SOUND RECNSTR] [ON]: Creates realistic sound by compensating the high-frequency
(Sound reconstruction) components and restoring the rise-time of the waveform that are lost in
audio data compression. ; [OFF]: Cancels.
• [SUB-W LEVEL]/[SUBWOOFER SET]/[LPF SUBWOOFER]/[SUB-W PHASE] is selectable
only if [SWITCH PREOUT] is set to [SUB-W]. (Page 4)
• [SUB-W LEVEL]/[LPF SUBWOOFER]/[SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON].
10
ENGLISH

DISPLAY SETTINGS

Zone identification for brightness setting
1
Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
[DISPLAY]
[DIMMER] Dims the illumination.
[ON]: Dimmer is turned on.
[OFF]: Dimmer is turned off.
[DIMMER TIME]: Set the dimmer on and off time.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
Default: [ON]: [18:00] ; [OFF]: [6:00]
[BRIGHTNESS] 1 Select a zone. (See the illustration above.)
2 [LVL 00] to [LVL 31]: Set the brightness level for the selected zone.
[TEXT SCROLL] [ONCE]: Scrolls the display information once. ; [AUTO]: Repeats scrolling at
5-second intervals. ; [OFF]: Cancels.
.
Default: [XX]