Connecting An Av Device With Component Output - Samsung BP59-00134G-01 Owner's Instructions Manual

2-16 Connecting an AV device with component output

First, Make sure that the AV device and your projector are turned off.
1. Connect the [PC IN] terminal on the back of the projector to the Component terminal on your AV device using a D-Sub to
Component cable (Not supplied). This cable has a D-Sub connector on one end and three RCA jacks on the other.
- For supported input signal formats, resolutions, and frequencies, see AV Timing (D-Sub) in Section 2-9.
2. Connect the [PC/DVI AUDIO IN] terminal on the back of the projector and the Audio out terminal on your AV device using an
audio cable (Not supplied).
Installation and Connection 2-16