Table of Contents
Advertisement
Your New Wide TV
Remote Control
You can use your remote control within a distance of 23 feet and an angle of 30 degrees from the left
and right sides of the TV's remote control receiver. You can also use your remote control to operate your
VCR, Cable box, DVD player and Set-top box. See pages 34~40 for details.
1. POWER
Turns the TV on and off.
2. Channel Number
Press to directly tune to a particular channel.
3. -
Use to select a channel over. For exemple,
for channel "122", press "-" then "2" then
"2".
4. ANTENNA
Press to select "AIR" or "CABLE". (STD, HRC,
IRC).
5. CH MGR
Used to display Channel Lists on the screen.
6. VCR/DVD Controls
Controls VCR or DVD functions: Rewind, Stop,
Play/Pause, Fast Forward.
7. VOL +, VOL -
Press to increase or decrease the volume.
8. MUTE
Press to mute the TV sound.
9. MENU
Displays the main on-screen menu.
10.
▲
,
▼
,
,
, ENTER
œ
√
Press to select highlight up, down, left, or
right. While using the on-screen menus,
press ENTER to activate (or change) a
particular item.
11. INFO
Press to display information on the TV
screen.
12. PIP (Picture In Picture)
PIP (Picture in Picture) ON/OFF.
13. S.MODE
Select Sound effect. (Refer to page 73)
14. P.MODE
Adjust the TV picture by selecting one of
the preset factory settings (or select your
personal, customized picture settings.)
(Refer to page 54)
15. MTS (Multichannel Television
Stereo)
Press to choose Stereo, SAP(Secondary Audio
Program) or Mono.
16. CAPTION
Controls the caption decoder.
17. Mode
(TV/DVD/STB/CABLE/VCR)
Selects a target device to be controlled by
the Samsung remote control (i.e., TV, DVD,
STB, CABLE, or VCR).
English - 12
18. SOURCE
Press to display all of the available video
sources (TV, AV1, AV2, AV3, S-Video1,
S-Video2, S-Video3, Component1,
Component2, PC, HDMI).
19. PRE-CH
Tunes to the previous channel.
20. DNIe (Digital Natural Image
engine)
Activates DNIe Demo mode.
(Refer to page 59)
21. SLEEP
Press to select a preset time interval for
automatic shut off.
(Refer to page 43)
22. CH
/
Press to change channels.
23. EXIT
Press to exit the menu.
24. SRS
Activates TruSurround. (Refer to page 77)
25. STILL
Press to pause the current screen.
(Refer to page 69)
26. P.SIZE
Press to change the screen size.
(Refer to page 57)
27. PIP control buttons
SWAP: Interchange the main and sub
picture. (Refer to page 65)
CH
/
: Press to display the available
channels in sequence. (These buttons change
channels in the PIP window only.)
(Refer to page 68)
28. RESET
If your remote control is not functioning
properly, take out the batteries and press
the reset button for about 2~3 seconds.
Re-insert the batteries and try using the
remote control again.
29. SET
Used during set up of this remote control,
so that it will work compatibly with other
devices (Set-top box, VCR, Cable box,
DVD, etc.)
NOTE
• This is a special remote
control for the visually
impaired, and has Braille
points on the POWER,
VOL +, VOL -, CH
STOP, and PLAY/PAUSE
buttons.
/
,
Advertisement
Table of Contents
