Front Panel Led Indicators; Rear Panel Jacks - Samsung HLN4365W1 Instruction Manual

Your New Wide TV

Front Panel LED Indicators

The three lights on the front panel indicate the status of your TV.
: Light is On
: Light is Blinking
: Light is Off
Timer Lamp Temp
Auto Timer ON/OFF has been set.
Standby state.
The picture will automatically appear in about 25 seconds.
Auto Timer ON/OFF has been set and the set will automatically be turned on in
about 25 seconds.
A cooling fan inside the set is not operating normally.
Lamp cover on rear of the set is not properly shut.
Check if the ventilation hole on the rear of the set is blocked, because if the
inner temperature is too high, the power will shut off.
Lamp may be defective. Please contact a certified technician.
• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
• The TV has a fan to keep the inside lamp from overheating. You'll occasionally hear it working.
14
Remote Control Sensor
Aim the remote control towards this spot on the TV.
Indication

Rear Panel Jacks

Use the rear panel jacks to connect components such as a VCR. You can connect different components
such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and
three set of component video input jacks on the rear panel of your TV. For more information, please see
"Connections".
Œ ANTENNA terminals ˆ Component1, 2, 3 jacks (Y, P
Two independent cables or antennas can be connected to these
terminals. Use ANT-A and ANT-B terminals to receive a signal from
VHF/UHF antennas or your cable system. Use the ANT A-OUT
terminal to send the signal being received by the ANT-A terminal out
to another component (such as a Cable Set Top Box).
Ø PC/DVI AUDIO INPUT jacks
The PIP channel can be received only when a signal source is
connected to ANT-A.
∏ DVI (Digital Video Interface) jack
´ S-VIDEO INPUT jacks
Connects an S-Video signal from an S-VHS VCR or DVD player.
" RS-232 jack
ˇ VIDEO/AUDIO INPUT jacks(VCR1, VCR2)
Connect video/audio signals from external sources, such as a VCR or
DVD players.
' PC VIDEO INPUT jack
¨ VIDEO/AUDIO MONITOR OUTPUT jacks
Sends a video signal from the TV to an external source, such as a
VCR.
Note: Monitor Out is available only in RF, Video and S-Video modes.
, P L, R)
B R,
Use these jacks to connect the component video/audio signals from a
DVD player or a set top box when using the component video input
jacks.
Connect these to the audio-output jacks on your PC or set top box.
Receives the digital signals from a set top box or PC etc.
The RS232 jack is for repair and software upgrades.
Connect to the video output port on your PC.
15