Setting Up Your Remote Control - Samsung HLN4365W1 Instruction Manual

Special Features

Setting Up Your Remote Control

This TV's remote control can operate almost any STB(Set-Top Box), VCR, cable box, or DVD.
After it has been set up properly, your remote control can operate in five different modes: TV,
STB(Set-Top Box), VCR, Cable, or DVD. Pressing the corresponding button on the remote control
allows you to switch between these modes, and control whichever piece of equipment you choose.
Note
The remote control might not be compatible with all DVD Players, VCRs and Cable boxes.
Setting Up the Remote to Operate Your VCR
Turn off your VCR.
1
Press the MODE button and make sure
2
that the VCR LED is illuminated.
The remote control has five "modes":
"TV", "STB", "VCR", "CABLE" and
"DVD".
On your Samsung remote control, press
3
the SET button.
Enter 3 digits of the VCR code listed on
4
the next page for your brand of VCR.
Make sure you enter 3 digits of the code,
even if the first digit is a "0".
If more than one code listed, try the first
one.
If your VCR does not turn on, repeat
steps 2, 3, and 4, but try one of the
other codes listed for the brand of your
particular VCR.
Press the POWER button on the remote
5
control. Your VCR should turn on. If your
VCR turns on, your remote control is now
set correctly.
Once your remote control is set up, press
6
the MODE button any time you want to
use the remote to operate your VCR.
Note on Using Remote Control Modes: VCR
• When your remote control is in "VCR" mode, the volume buttons still control your TV's volume.
50
Setting Up the Remote to Operate Your Cable Box
Turn off your cable box.
1
Press the MODE button and make sure
2
that the CABLE LED is illuminated.
The remote control has five "modes":
"TV", "STB", "VCR", "CABLE" and
"DVD".
On your Samsung remote control, press
3
the SET button.
Enter 3 digits of the cable box code
4
listed below for your brand of cable box.
Make sure you enter 3 digits of the code,
even if the first digit is a "0". (If more
than one code listed, try the first one.)
If your cable box does not turn on,
repeat steps 2, 3, and 4, but try one of
the other codes listed for your particular
brand of cable box.
Press the POWER button. Your cable box
5
should turn on. If your cable box turns
on, your remote control is now "set up"
correctly.
Once your remote control is set up, press
6
the MODE button any time you want to
use the remote to operate your cable
box.
Note on Using Remote Control Modes: Cable Box
• When your remote control is in "Cable Box" mode, the volume buttons still control your TV's
volume.
51