Transfer Stored Data - Konica Minolta CR-400 Instruction Manual

Optional Setting
<Transfer Stored Data>
It is possible to transfer data stored in the measuring head to the data processor.
Import actually moves the data, and does not simply copy it.
Selecting multi-calibration in P.115 displays the [multi-calibration] selection screen.
Move the cursor using the
1
to import.
• After the processing screen, import is complete, and the dis-
play returns to the measurement screen.
• If the selected page contains data, newer data is registered af-
ter the existing data.
• Import will not be performed if there are more than 2000 sets
of data.
Press the Measure/Enter key
2
If you press the Escape key when data transfer is executed, the data transfer operation stops.
In this case, data transfer until the stop point has been completed. Since data transfer is ex-
ecuted in sequence from the oldest data, the measurement screen on the measuring head
display is apparently unchanged (the latest measurement data are displayed on the screen),
but the measuring head retains data that have not been transferred.
126
key and select the page
.
1
2
Selection screen
Processing screen