Before You Start Using The Equipment - Calmetrix I-Cal 8000 User Manual

Calmetrix I-Cal 8000 User Manual
A. BEFORE YOU START USING THE EQUIPMENT
Unpacking your I-Cal 8000.
Your I-Cal is shipped in two separate boxes.
One box contains the calorimeter unit
The other box contains the temperature control unit.
1. Open both boxes and unpack the calorimeter and the temperature control unit. Remove all
protective pads and packaging materials. Make sure you find the Accessories box located inside
the temperature control unit.
2. Place the Temperature Control Unit in the place where testing will usually be conducted within your
lab. Ensure that the unit is in proximity to a power source.
3. Place the Calorimeter Unit into the Temperature Control Unit and connect the Calorimeter USB
cable to the internal USB plug
4. Never lift or transport your I-Cal 8000 while the Calorimeter Unit is placed inside the Temperature
Control Unit. Always remove the Calorimeter Unit first.
Installing your CalCommander Software.
Minimum requirements: Windows XP or later, 1 GB RAM and 250MB hard drive space, screen resolution of
1024x768 or higher.
Do not yet connect your I-Cal unit. Install your software first:
1. Insert the CalCommander CD in your CD/DVD drive and follow the on-screen installation
instructions. The Installer will first install the PDF converter, then the CalCommander software.
Refer to detailed instructions on the Quick Set-Up sheet enclosed in the Accessories box.
2. Restart your Computer
3. Click on the CalCommander in your Desktop Icon to open CalCommander
4. Click on the Settings tab
5. Email your ID number to
Registration number. Once received, key in the number in the Reg ID field.
registration@calmetrix.com
© 2010 - 2012 Calmetrix Inc. – All rights reserved
or call +1 617-203-2090 to obtain your
7