AOS Release 6.4.6.R01 Release Notes
System Requirements
Memory Requirements
•
OmniSwitch 6850E Series Release 6.4.6.R01 requires 512 MB of SDRAM and 128 MB of
flash memory. This is the standard configuration shipped.
•
OmniSwitch 6855 Series Release 6.4.6.R01 requires 256 MB of SDRAM and 128 MB flash
memory. This is the standard configuration shipped.
•
OmniSwitch 9000E Series Release 6.4.6.R01 requires 1GB of SDRAM and 256 MB of flash
memory for the Chassis Management Module (CMM). This is the standard configuration
shipped.
Configuration files and the compressed software images—including web management software
(WebView) images—are stored in the flash memory. Use the show hardware info command to
determine your SDRAM and flash memory.
UBoot, FPGA, Miniboot, BootROM, Upgrade Requirements
The software versions listed below are the MINIMUM required, except where otherwise noted.
Switches running the minimum versions, as listed below, do not require any Uboot, Miniboot, or
FPGA upgrades when upgrading to AOS 6.4.6.R01.
Switches not running the minimum version required should upgrade to the latest Uboot, Miniboot,
FPGA that is available with the 6.4.6.R01 AOS software available from Service & Support.
Note: Refer to the
6.4.6.R01 Upgrade Instructions
to Release 6.4.6.R01.
OmniSwitch 9000E
Release
Miniboot.uboot CMM
CMM/NI
6.4.3.479.R01
with Old
Flash
6.4.6.125.R01
CMM/NI
6.4.4.506.R01
with New
Flash
6.4.6.125.R01
Note: Refer to the
Required Minimum Uboot for Modules with New Flash Component
determining OS9000E module Flash components.
OmniSwitch 6850E/6855/9000E------ Release 6.4.6.R01
section for step-by-step instructions on upgrading
UBoot CMM
UBoot NI
6.4.3.479.R01
6.4.3.479.R01
6.4.4.506.R01
6.4.4.506.R01
November 2013
FPGA CMM
Major Revision: 2
Minor Revision: 25
(displays as 0x19;
recommended)
Major Revision: 2
Minor Revision: 25
(displays as 0x19;
recommended)
for help with
Page 5 of 80