Configuring L2Tpv3 Pseudowires; Configuring A Dynamic L2Tpv3 Pseudowire - Cisco CRS Configuration Manual

Implementing Layer 2 Tunnel Protocol Version 3
Example:
RP/0/RP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2tp-class word
Example:
RP/0/RP0/CPU0:router(config)# l2tp-class class1
Specifies the L2TP class name and enters L2TP class configuration mode.
Step 3 hello interval
Example:
RP/0/RP0/CPU0:router(config-l2tp-class)# hello 100
Specifies the exchange interval (in seconds) used between L2TP hello packets.
• Valid values for the interval argument range from 0 to 1000. The default value is 60.

Configuring L2TPv3 Pseudowires

Perform the following tasks to configure static and dynamic L2TPv3 pseudowires:

Configuring a Dynamic L2TPv3 Pseudowire

Perform this task to configure a dynamic L2TPv3 pseudowire.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group name
4. p2p name
5. neighbor ip-address pw-id number
6. pw-class pw-class-name
7. Use the commit or end command.
8. pw-class pw-class-name
9. encapsulation l2tpv3
10. protocol l2tpv3 class class - name
11. Use the commit or end command.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring L2TPv3 Pseudowires
163