Understanding Display Messages - Samsung ML-3051N User Manual

Understanding display messages

Messages appear on the Smart Panel program window or the control
panel display to indicate the printer's status or errors. Refer to the tables
below to understand the messages' meaning and correct the problem if
necessary. Messages and their meanings are listed in alphabetical
order.
Note
When you call for service, it is very convenient to tell the
service representative the display message.
Message Meaning
The front cover or
Door Open
rear cover is not
securely latched.
Paper has jammed
Duplex Jam 0
during duplex
Check Inside
printing.
Paper has jammed
Duplex Jam 1 Open/
during duplex
Close Door
printing.
The fuser door is
Fuser Door Open
not securely latched.
The multi-purpose
Load Manually
tray is empty in
Press Stop Key
manual feed mode.
There is a problem
Low Heat Error
in the fuser unit.
Cycle Power
A problem has
LSU Hsync Error
occurred in the LSU
Cycle Power
(Laser Scanning
Unit).
A problem has
LSU Motor Error
occurred in the LSU
Cycle Power
(Laser Scanning
Unit).
Suggested solutions
Close the cover until
it locks into place.
Clear the jam. See
page 9.4.
Clear the jam. See
page 9.5.
Open the rear cover
and close the fuser
door until it locks into
place.
For the location of
the fuser door, see
page 9.4.
Load a sheet of print
material and press
Stop.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
inches. If the
problem persists,
please call for
service.
Unplug the power
cord and plug it back
inches. If the
problem persists,
please call for
service.
9.7
Message
There is a problem
Main Motor Locked
in the main motor.
There is a problem
Open Heat Error
in the fuser unit.
Cycle Power
There is a problem
Over Heat Error
in the fuser unit.
Cycle Power
Paper has jammed
Paper Jam 0
in the feeding area
Open/Close Door
of the tray.
Paper has jammed
Paper Jam 1
in the fuser area.
Open/Close Door
Paper has jammed
Paper Jam 2
in the paper exit
Check Inside
area.
The printer is
printing jobs using
Printing...
the displayed
language.
The printer is on-line
Ready
and ready to printer.
The engine in your
Self Diagnostic...
printer is checking
some problems
detected.
The printer is on
Sleeping...
power save mode.
There is no paper in
Tray 1
the tray 1.
Paper Empty
There is no paper in
Tray 2
the optional tray 2.
Paper Empty
<Troubleshooting>
Meaning Suggested solutions
Open and then close
the front cover.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Clear the jam. See
page 9.1 and
page 9.1.
Clear the jam. See
page 9.3.
Clear the jam. See
page 9.3.
Complete your
printing.
Use your printer.
Please wait a few
minutes.
When data is
received, it switches
to on-line
automatically.
Load paper in the
tray 1. See page 5.5.
Load paper in the
optional tray 2. See
page 5.5.