Pcl Menu - Samsung ML 3560 User Manual

Item
Values: Off, On*
This item determines whether or not the
printer continues printing when it detects the
paper unmatched to your paper setting.
Auto
• Off: If the paper mismatch occurs, the
Continue
message will remain on the display and the
printer will remain off-line until you insert
the correct paper.
• On: If the paper mismatch occurs, an error
message will display. The printer will go
offline for 30 seconds and automatically
clear the message and continue printing.
Values: Off*, On
This item determines how the printer behaves
when a paper jam occurs.
JAM Recovery
• Off: The printer does not reprint pages.
Printing performance might be increased
with this setting.
• On: The printer automatically reprints
pages after you clear the paper jam.
Values: Low*, High
Altitude Adj.
You can optimize print quality depending on
the air pressure, such as in a high ground.
Values: LF*, LF+CR
This item allows you to append the required
carriage return to each line feed.
Auto CR
Refer to the following samples:
AA
BB
LF
Values: 0 ~ 1800 sec
You can set the time length the printer waits
Job Time Out
before printing the last page of a print job that
does not end with a command to print the
page.
When a job time-out occurs, the printer prints
the page in the print buffer.
Explanation
AA
BB
LF+CR
*15 sec
3.7
Using the Control Panel
Item
This item allows you to maintain the toner
cartridge.
• OPC Cleaning: Cleans the OPC drum of
the cartridge and produces a cleaning sheet
with toner debris on it.
Maintenance • Fuser Cleaning: Cleans the fuser unit
inside of the printer and produces a cleaning
sheet with toner debris on it.
• Life Remaining: This item allows you to
check how much toner are left in the
cartridge.

PCL Menu

This menu sets the PCL emulation configuration. You can set
the font type, symbol type, lines per page, and point size.
(*: the default setting)
Item Explanation
Values: PCL1* ~ PCL68
You can select the standard font to be used in PCL
emulation.
• PCL1~PCL7's interval between letters is fixed,
Typeface
and PCL8~PCL45's interval is proportional to
the font type and point size. You can adjust the
font size of PCL1~PCL7 using the Pitch item,
and PCL8~PCL45 can do using Point Size
item.
• PCL46~PCL54's interval and point size are
fixed.
Values: ROMAN8 ~ PCCYRILLIC
Symbol
This item selects the symbol to be used in PCL
emulation. The symbol is the group of numbers,
marks, and special signs being used when
printing letters.
Values: 5 ~ 128
Lines
This item allows you to set vertical spacing from 5
to 128 lines for the default paper size. The lines
may differ according to the paper size and
printing orientation.
Explanation
*PC8
*60 (Letter), 64 (A4)