Media Sizes Supported In Each Mode; Guidelines For Special Print Media - Samsung CLP-610 Series User Manual

Media sizes supported in each mode

Mode Size
Single side All sizes All weights
printing supported by supported by
the machine the machine
Duplex Letter, A4, 75 to 90 g/m
a
printing Legal, Folio, (20 to 24 lb
Oficio bond)
2
a. 75 to 105 g/m (20 ~ 28 lb bond) only, and this feature is supported in
CLP-6xxND.

Guidelines for special print media

Media type
Envelopes • Successful printing on envelopes depends upon
the quality of the envelopes. When selecting
envelopes, consider the following factors:
- Weight: The weight of the envelope paper
should not exceed 90 g/m
occur.
- Construction: Prior to printing, envelopes
should lie flat with less than 6 mm curl, and
should not contain air.
- Condition: Envelopes should not be wrinkled,
nicked, or otherwise damaged.
- Temperature: You should use envelopes that
are compatible with the heat and pressure of
the machine during operation.
• Use only well-constructed envelopes with sharp
and well creased folds.
• Do not use stamped envelopes.
• Do not use envelopes with clasps, snaps,
windows, coated lining, self-adhesive seals, or
other synthetic materials.
• Do not use damaged or poorly made envelopes.
• Be sure the seam at both ends of the envelope
extends all the way to the corner of the
envelope.
Acceptable
Unacceptable
Weight Source
• tray 1
• optional tray
• multi-purpose tray
2
• tray 1
• optional tray
• multi-purpose tray
Guidelines
2
or jamming may
Media type
• Envelopes with a peel-off adhesive strip or with
more than one flap that folds over to seal must
use adhesives compatible with the machine's
fusing temperature for 0.1 second. Check your
machine's specification to view the fusing
temperature, see page 10.1. The extra flaps and
strips might cause wrinkling, creasing, or jams,
and may even damage the fuser.
• For the best print quality, position margins no
closer than 15 mm from the edges of the
envelope.
• Avoid printing over the area where the
envelope's seams meet.
Labels • To avoid damaging the machine, use only labels
designed for use in laser machines.
• When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
stable at your machine's fusing temperature.
Check your machine's specification to view the
fusing temperature, see page 10.1.
- Arrangement: Only use labels with no
exposed backing between them. Labels can
peel off sheets that have spaces between the
labels, causing serious jams.
- Curl: Prior to printing, labels must lie flat with
no more than 13 mm of curl in any direction.
- Condition: Do not use labels with wrinkles,
bubbles, or other indications of separation.
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can
cause labels to peel off during printing, which
can cause paper jams. Exposed adhesive can
also cause damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is
designed for only a single pass through the
machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or
otherwise damaged.
Card stock or • Do not print on media smaller than 76 mm wide
custom-sized
or 356 mm long.
materials
• In the software application, set margins at least
6.4 mm away from the edges of the material.
4.3
<Selecting and loading print media>
Guidelines