Roland Octapad SPD-20X Owner's Manual page 23

How to edit
1
2
3
You can speed up the change in values by pressing [+] while holding down [-] (or vice versa).
MEMO
4
5
22
Press [EDIT] to enter the Edit mode.
Select the parameter you wish to edit. Press [SOUND], [MIDI/PEDAL],
[FX/UTILITY], and [SYSTEM] button directly or press [SELECT] to get the
appropriate indicator to light, thus selecting a column. Use [
select the desired row, by getting the appropriate indicatorto light. (The
display will show the value of the selected parameter.)
[SELECT] chooses the parameter group. The parameters of the SPD-20 are organized
into four groups: SOUND, MIDI/PEDAL, FX/UTILITY, and SYSTEM. With each press of
[SELECT], the indicator that lights (and the group that is selected), will be the next
one in this group. The [
parameter groups. The indicator above the currently lighted one will light when you
press [ ], and the onebelow the one currently lighted will light when you press [
In this illustration, the NOTE# parameter in the MIDI/PEDAL parameter group is
selected.
Use PATCH/VALUE [-] or [+] to set the value. The previous value of the
parameter will be discarded. In the case of a numerical value, PATCH/
VALUE [+] increases the value, and PATCH/VALUE [-] decreases it.
If you wish to edit another parameter, repeat steps 2–3 as necessary.
Press [EDIT] to return to the Play mode.
The parameter list indicators will go out, and the display will once again show the
Patch number.
] and [ ] buttons are used to select parameters within the
] or [ ] to
].