Table of Contents
Advertisement
Connecting water (Water dispensing and Automatic Ice models)
Ensure the refrigerator is NOT plugged into a
1
power supply. Locate the isolation tap for water
connection – cold water supply only. (Tee and
tap fitting not supplied).
Uncoil a tubing with quick fitting from the back
2
of the refrigerator (refer to A).
– The quick fitting is pre-assembled with
the tubing at the factory.
Connect one end of a long tubing (4m) to the
3
quick fitting, and insert the other end to a PLV
(refer to B).
Insert one end of a short tubing (200mm) to
4
the inlet of the PLV. (Refer to C).
– Ensure the arrow on the PLV is pointing
away from the tap. The arrow indicates
the direction of water flow.
Insert the other end of the short tubing firmly
5
to the tap connection. (Refer to C).
– The tubing should push in at least 16mm
before reaching the stop.
Pull gently on the short tubing to ensure it is
6
locked in place (refer to D).
Secure the connection by attaching a locking
7
key in between the tap connection and
locking collet (refer to E).
Fasten the tap connection to the cold water
8
supply tap. Take care not to over-tighten the
tap connection (refer to F).
Note: The tap connection supplied should fit
most installation situations.
Turn isolating tap on and check that all
9
connections are dry and free of drips.
INSTALLATION INSTRUCTIONS
tap connection
4m tubing
E
C
200mm tubing
PLV
A
quick fitting
D
Pull gently on tubing to
ensure it is locked in.
F
B
13
Hide quick links:
Advertisement
Table of Contents
