Sbus Basic Menu (S.bus Basic Setting) - FUTABA CGY760R Instruction Manual

S
BUS
The "
From 3/3
SBUS BASIC screen 1/3
(1) S. BUS connection: AIL (Aileron) channel
Move the cursor to "AIL CH #" by pressing the [
the [Enter] key to enter the setting mode. Use the [
the aileron channel of the transmitter. When you are done, press [Enter]
key to finish. Follow this procedure to make the adjustments to to all chan-
nels below.
(2) S. BUS connection: ELE (Elevator) channel
Using the [
(3) S. BUS connection: THR (Throttle) channel
Using the [
(4) S. BUS connection: RUD (Rudder) channel
Using the [
(5) S. BUS connection: PIT (Pitch) channel
Using the [
B M
ENU ( S.BUS BASIC SETTING )
ASIC
" screen is accessed via the "
From the "RESET" of
SBUS BASIC screen 3/3
Go to 2/3 from any
cursor position
:
:
/
+] or [
/
+] or [
/
+] or [
/
+] or [
WARNING
Always verify that the S.BUS function as-
signments match your transmitter's function
(in the FUNCTION menu) assignments. If
any changes are made within the transmit-
ter function assignments, then it will also be
necessary to make the changes within the
S.BUS function assignments. Change the
setting with the transmitter turned off.
:
/
-] key to set the correct channel number.
/
-] key to set the correct channel number.
/
-] key to set the correct channel number.
/
-] key to set the correct channel number.
40
" screen (see page
Settings (all in common):
1 to 16ch, DG1, DG2, INH
/ /
+] or [ -] key and press
/ /
+] or [ -] key to set