Canon iPF671 Service Manual page 52

Chapter 1
[GL2 Settings] [Line&Pen
Manager]
[ProcessingOp
tion]
[GL2 Set Print]
1-38
Setting Item
[Enable merge]
[Pen Setup] [Select
Palette]
[Define
Palette]
[Reset Palette] Return the [Define Palette] settings to factory settings.
[Smoothing]
[ThickenFineLines]
[AdjustFaintLines]
[Ln Wdth correct]
[Detect img size]
[Warning]
[On-the-Fly]
Description/Instructions
When lines overlap, set whether to merge or overwrite the colors of the overlapping lines.
Select [Off] to overwrite with the line printed later. Select [On] to merge all overlapping colors.
Select the value related to pen from [Software], [Palette A], [Palette B], or [Factory].
Select [Software] to print according to the application side instruction. Select [Palette A] or
[Palette B] to print with value set by [Define Palette].
Set [Width], [Color], and [Line Attributes] for the palette's [Pen Number]. Select [Factory] to
check the value when [Factory] is selected for [Select Palette].
For [Line Attributes], select the shape of line end and joint between lines as [No Setting] or
[Circle Setting].
Choose whether to draw an arc with a smooth curve or with a polygon.
Select [On] to print thin lines clearly.
If thin lines print in a tint of color varied from other patterns, selecting [Off] may provide the
print result as intended, though the thin lines may print, interrupted, depending on the color.
Correct the width of lines. (The basic line width is set using the [Pen Setup] funstion)
Select [Black/gray] to correct the width of lines whrere all of the RGB values are the same
(except when R=G=B=255). The setting value can be set in the range of -20 to +20, with the
setting value given in units of correction of 0.025mm. When set to -20, lines become 0.5mm
thinner, and when set to +20, lines become 0.5mm thicker.
Select [Color] to correct the width of lines that are not [Black/gray]. The setting value can be
set in the range of -20 to +20 with the setting value given in units of correction of 0.025mm.
When set to -20 lines become 0.5mm thinner, and when set to +20 lines become 0.5mm thicker
Set the method for selecting the rendering region.
Select [Off] to use the value from the PS command in the input data. If there are no PS
commands, prints using the maximum size (maximum roll paper width X (maximum roll paper
width X 1.5)). This reduces the printing time compared with the cases whrere [Command
priority] or [Detected size] are set because the data analysis finishes in a shorter period of time.
Select [On] to display warnings during GL2.
In printing data consisting solely of HP RTL, if the data is slow to print, select [On] to expedite
the time at which the data starts printing. Verify the print result to make sure that images are
not chipped in this case.
Print the GL2 settings.