Safety Precautions - Vinotemp VT-46SSDST Service Manual

12.SAFETY PRECAUTIONS

When the equipment is used, it is required to always observe basic precaution measures so as to
minimize fire, electric shock and personal hazard. These basic precautions include:
12.1 For Your Safety:
Even if you are familiar with this device, you are required to read all the instructions carefully.
l This device will be used only based on the description in these Instructions. Other operation methods
not suggested may lead to fire, electric shock or personal injury.
l This device is not intended to be operated or used by children or the old or the weak, unless under
the adequate custody by personnel responsible so as to ensure that they can use this device safely.
l Take good care of children to ensure that they will not play with this device.
l In order to avoid any risk in electric shock, never spray any liquid onto the body of the device,
power cords or plugs or dip it in water.
l When this device is not used, or before it is moved to another place or is cleaned, please pull the
plug of the device out of the socket.
l To disconnect the device, please hold the plug, and pull it out of the socket on the wall. Never pull
the power cord.
l Do not operate this device at flammable and explosive places.
l Do not put this device or any part thereof in the vicinity of open fore, cookware or other electric
heating devices.
l Do not use damaged power cords or plugs. Do not use defective or dropped or otherwise damaged
devices.
l Use of any accessory device not recommended for use by the manufacturer might cause dangers.
l Put the device on a dry and horizontal surface.
l If the housing is damaged or removed, do not operate or use this device.
l Loose connection between the AC power socket and the plug may result in overheat or deformation
of the plug. Contact an electrician holding his certificate to replace the loose or damaged socket.
l Put the device far away from direct sunshine and heats sources (such as furnaces, heaters and
radiators).
l This device contains no CFC or HFC, but contains a small amount of environment friendly coolant
called isobutane (R600a).
l During device installation, make sure that it will not damage refrigerant cycle. In any case, if the
refrigerant cycle is damaged, please try not to be close to open fore and heat sources of various kinds.
The room where the device is put must be ventilated for several minutes.
l Never use the device whose cooling cycle is damaged.
l Ensure that the air inlet vent of the built-in drinks cabinet will not be blocked or kept out. For any
damage due to improper use of this device or operation of this device by unqualified personnel, we
will not assume any liability. This case will not be covered by the warranty, and will not be
applicable to any claim for damages.
l Warning: Do not operate any electric device within this device.
l Except expressly stated in these Instructions, do not attempt to repair this device or change any
device parts. For all other repairs, please consult qualified technicians.
l Before operation, please mount back all panels.
l Two or more persons are required to move or install the device. Otherwise, it may result in injury at
the back or other parts.
l Never use flammable liquid to clean parts and components of the device. These volatile gases may
result in a fire or explosion. Do not store or use gasoline or other flammable gases or liquids near
this electric appliance or other electric devices, for volatile gases may result in a risk in fire or
explosion.
l When hands are wet, do not connect or disconnect the power plug.
l It is recommended that you use standalone circuit circulation to supply power for your device. Use
the socket that can be switched off by switches or pull locks.
Warning: To reduce risk in fire, electric shock or personal injury, please pull out the
plug or disconnect the power with the electric dev ice.
17