Electric Connection - Vinotemp VT-46SSDST Service Manual

11.ELECTRIC CONNECTION

Check whether the voltage marked on the product is consistent with your supply voltage.
Warning: Improper use of grounding plugs may result in risk in electric shock. If the power cord is
damaged, allow eligible technicians or an authorized service center to replace it.
For your safety, this device must be properly grounded. This electric device is provided with 3-pin plugs
applicable to 3-hole wall mounted socket so as to minimize the possibility of electric shock.
In no case may the third grounding pin attached to the power cord be reduced or removed. For personal
safety, this device must be properly grounded.
This device must have a standard American style 3-pin electric grounding socket. Qualified technicians
will be requested to check the socket and circuits on the wall to ensure proper grounding of the socket. If
it is a standard 2-pin wall-mounted socket, you will have the liability and obligation to have somebody
replace it as the 3-pin wall mounted socket with good grounding.
Power cords must be fixed at the back of the device, and may not be in the state of exposure or shaking
so as to prevent incidental injury.
This device must always be inserted on a standalone electric socket consistent with the rated voltage as
shown on the label of rated voltage and device. This can enable the electric device to have the optimal
performance, and can put indoor circuit circulating overload so as to prevent any risk in a fire caused by
overheat. Never pull the power cord to remove the device socket. Always hold the plug, and directly pull
it out of the socket. The worn or damaged power cords must be repaired or replaced immediately. Do not
use power cords cracked or damaged in the middle or at both ends. When the device is moved, be careful
not to damage the power cords.
It is required to provide at least 10 ampere electric fuse protection. If the socket is unable to reach after
the installation of the device, then it is required to take corresponding actions in the electric installation
process so as to ensure that the device will be disconnected from the main power supply.
Do not use any extended wires for your device, unless such an extended wire is checked by qualified
electricians or service personnel. The extended wire must meet the local relevant requirements, with the
rated power of the extended wire at 110V~ and at least 10 amperes.
16